Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

A
OK
(b) Turn the ignition switch off.
(c) Check if DTCs U0073, U0123, C1210 and/or C1336 are output .
Result
RESULT PROCEED TO
DTC U0073, U0123, C1210 and/or C1336 are not output A
DTC U0073 and/or U0123 are output B
DTC C1210 and/or C1336 are output C
B
GO TO CAN COMMUNICATION SYSTEM (HOW TO
PROCEED WITH TROUBLESHOOTING)
C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
2. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
(a) Check that the yaw rate and acceleration sensor (airbag sensor assembly) is installed properly .
OK:
The sensor is tightened to the specified torque.
The sensor is not tilted.
NG
INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY
3. CHECK HARNESS AND CONNECTOR (IG2, E1, E2 TERMINAL)
(a) Disconnect the yaw rate and acceleration sensor (airbag
sensor assembly) connector.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *