Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(d) Connect the vinyl tube to the rear wheel cylinder.
(e) Loosen the bleeder plug.
(f) Select "TRAC Solenoid (SRMF & SRMR)" to drive the solenoids and bleed air from the rear wheel cylinder
(step F).
NOTICE:
Do not depress the brake pedal.
Keep brake fluid in the reservoir tank above the MIN line during the above procedures.
HINT:
Brake fluid is sent through the pump.
To protect the solenoids, the Techstream turns OFF automatically 2 seconds after every solenoid has been
turned ON.
(g) Repeat step F until all the air in the brake fluid is bled out.
(h) When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug.
Torque:
11 N·m {110 kgf·cm, 8ft·lbf}
(i) Repeat the above procedures to bleed the other brake line.
(j) Turn the ignition switch to OFF.
(k) Turn the ignition switch to ON.
(l) Clear DTC .
5. INSPECT FOR BRAKE FLUID LEAK
6. INSPECT FLUID LEVEL IN RESERVOIR
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *