Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

NEXT
OK
2. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
(a) Perform zero point calibration of the yaw rate and acceleration sensor .
3. PERFORM TEST MODE (SIGNAL CHECK)
(a) Turn the ignition switch off.
(b) Perform the signal check in the Test Mode Procedure .
OK:
All test mode DTCs are cleared.
NG
GO TO STEP 4
OK
END
4. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
(a) Turn the ignition switch off.
(b) Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed
properly .
OK:
The sensor is tightened to the specified torque.
The sensor is not installed at an angle.
NG
INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY
5. READ VALUE USING TECHSTREAM (YAW RATE AND ACCELERA
TION SENSOR)
(a) Turn the ignition switch off.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *