Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
Last Modified: 11-13-2015 6.6 J Doc ID: RM00000451R01NX
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): Brake Warning
Light does not Come ON; 2016 MY Tacoma [08/2015 - ]
Brake Warning Light does not Come ON
DESCRIPTION
Refer to Brake Warning Light Remains ON .
WIRING DIAGRAM
Refer to Brake Warning Light Remains ON .
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform calibration .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1.
CHECK CAN COMMUNICATION SYSTEM
NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO
PROCEED WITH TROUBLESHOOTING)
2. PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
(f) According to the display on the Techstream, perform the Active Test.
ABS/VSC/TRAC
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *