Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(b) Front brake line.
(1) Connect the vinyl tube to the brake caliper.
(2) Depress the brake pedal several times, then loosen the
bleeder plug with the pedal held down (step D).
(3) At the point when the fluid stops coming out, tighten the
bleeder plug, then release the brake pedal (step E).
(4) Repeat step D and E until all the air in the fluid has been bled
out.
Torque:
11 N·m {110 kgf·cm, 8ft·lbf}
(5) Repeat the above procedures to bleed the other brake line.
(c) Rear brake line.
(1) Connect the vinyl tube to the wheel cylinder.
(2) Depress the brake pedal, hold it, and then loosen the bleeder
plug.
HINT:
Brake fluid is pumped out automatically.
(3) Loosen the bleeder plug and release air.
NOTICE:
Keep brake fluid in the reservoir tank above the MIN line during
the above procedures.
(4) When the air is completely bled out of the brake
fluid through
the bleeder plug, tighten the bleeder plug.
Torque:
11 N·m {110 kgf·cm, 8ft·lbf}
(5) Repeat the above procedures to bleed the other brake line.
4. BLEED MASTER CYLINDER SOLENOID
HINT:
If the brake master cylinder is disassembled, the brake line is disconnected from the brake master cylinder
or if the reservoir become empty, bleed the brake master cylinder.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Select "Active Test" mode on the Techstream.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *