Tacoma

Toyota Tacoma 2015-2018 Air Conditioning Workshop Manual

A
1. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Operate the recirculation/fresh switch.
(e) Enter the following menus: Body Electrical / Air Conditioner / Data List.
(f) Check the value(s) by referring to the table below.
Air Conditioner
TESTER DISPLAY MEASUREMENT ITEM/RANGE NORMAL CONDITION DIAGNOSTIC
NOTE
Air Inlet Damper
Position
Air inlet damper servo motor actual position /
Air inlet damper servo motor actual position /
Min.: -14.0%
Max.: 113.5%
FRESH: 0.0%
RECIRCULATION:
100.0%
-
Air Inlet Damper
Target
Air inlet damper servo motor target position /
Min.: -14.0%
Max.: 113.5%
FRESH: 0.0%
RECIRCULATION:
100.0%
-
OK:
The display is as specified in the Normal Condition column.
RESULT PROCEED TO
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C
B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN
PROBLEM SYMPTOMS TABLE
C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY
2.
I
NSPECT NO. 1 AIR CONDITIONING SERVO ASSEMBLY (FRESH/RECIRCULATION
DAMPER)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *