Tacoma

Toyota Tacoma 2015-2018 Air Conditioning Workshop Manual

(g) Using SST, hold the magnet clutch hub and install the bolt.
SST: 09985-00260
Torque:
13.5 N·m {138 kgf·cm, 10ft·lbf}
NOTICE:
Make sure that there is no foreign matter or oil on the
compressor shaft, bolt, and clutch hub.
2. INSTALL PRESSURE RELIEF VALVE
(a) Apply sufficient compressor oil to a new O-ring and fitting surface of the pressure relief valve.
Compressor oil:
for HFC-134a (R134a)
ND-OIL 8 or equivalent
for HFO-1234yf (R1234yf)
ND-OIL 12 or equivalent
(b) Install a new O-ring onto the pressure relief valve.
(c) Install the pressure relief valve.
Torque:
8.0 N·m {82 kgf·cm, 71in·lbf}
3. INSPECT MAGNET CLUTCH CLEARANCE
(a) Secure the cooler compressor assembly in a vise between
aluminum plates.
Text in Illustration
*a
Component without harness connected
(Magnet Clutch Assembly)
(b) Set the dial indicator to the magnet clutch hub.
(c) Connect the battery positive lead to terminal 1 (MG+) of the magnet clutch connector and the negative
lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.
Standard clearance:
0.30 to 0.60 mm (0.012 to 0.024 in.)
If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the
clearance using compressor spacer to obtain the standard clearance.
Compressor spacer thickness:
0.2 mm (0.008 in.)
0.3 mm (0.012 in.)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *