SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SPEED SENSOR


C138516E01

  1. Coat the 2 bolts with ATF.

  1. Install the speed sensor to the valve body with the 2 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Connect the connector.



2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

  1. Coat the O-ring of the transmission wire connector with ATF.

  1. Align the groove of the manual valve with the manual valve lever.



    C136689E02

  1. Install the valve body to the transaxle case with the 11 bolts.

    NOTICE:
    1. When installing the transmission valve body assembly, be careful not to allow the speed sensor and transaxle case to interfere with each other.
    2. Temporarily install the bolts marked *1 in the illustration first because they are positioning bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    Bolt A: 25 mm (0.984 in.)
    Bolt B: 30 mm (1.18 in.)
    Bolt C: 35 mm (1.38 in.)
    Bolt D: 45 mm (1.77 in.)
    Bolt E: 55 mm (2.17 in.)


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


C136688

  1. Coat a new O-ring with ATF and install it to the oil strainer.

    NOTICE:
    Ensure that the O-ring is not twisted or pinched.


    C136687

  1. Install the oil strainer to the valve body with the 2 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }


4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


C134963E05

  1. Install the 2 magnets to the oil pan.

    Text in Illustration 
    *1
    		Magnet

  1. Install a new gasket to the oil pan.



    C134962E01

  1. Apply seal packing to the bolt labeled A in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing 1281,
    Three Bond 1281 or equivalent

  1. Install the oil pan to the automatic transaxle with the 18 bolts.

    Torque:
    for bolt labeled A:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
    for other bolts:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    1. In order to ensure proper sealing of the transmission oil pan bolt, apply seal packing to the bolt and install it within 10 minutes of seal packing application.
    2. Completely remove any oil or grease from the contact surfaces of the transaxle case, oil pan sub-assembly and gasket before installation.


5. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH


C207602

  1. Install the front suspension member reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 979 kgf*cm , 71 ft.*lbf }


6. ADD AUTOMATIC TRANSAXLE FLUID

  1. Add automatic transaxle fluid (Click here).



7. INSTALL REAR ENGINE UNDER COVER LH

  1. Install the under cover with the 2 clips.



8. INSTALL NO. 1 ENGINE UNDER COVER

  1. Install the engine under cover with the 6 bolts and 10 clips.