DTC B2799 Engine Immobiliser System Malfunction |
for Preparation Click here
DESCRIPTION
This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.DTC Code | DTC Detection Condition | Trouble Area |
B2799 | One of following conditions is met:
|
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for DTC.
- OK:
- B2799 output does not reoccur.
|
| ||||
OK | ||
|
2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - ECM) |
Disconnect the E50 ECU connector.
Disconnect the A12 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard Resistance:
Tester Connection Condition Specified Condition E50-13 (EFIO) - A12-16 (IMI) Always Below 1 Ω E50-12 (EFII) - A12-15 (IMO) Always E50-13 (EFIO) or A12-16 (IMI) - Body ground Always 10 kΩ or higher E50-12 (EFII) or A12-15 (IMO) - Body ground Always
|
| ||||
OK | |
3.CHECK TRANSPONDER KEY ECU (OPERATION) |
Temporarily replace the transponder key ECU with a new one.
Check that the engine starts normally.
- OK:
- Engine starts normally.
Result Result Proceed to OK A NG (for 2AD-FHV) B NG (for 2AD-FTV) C
|
| ||||
|
| ||||
A | ||
|