FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

  1. Detach the wire harness clamp from bracket.



    B127928

  1. Disconnect the connector from the airbag.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Remove the 2 bolts from the reinforcement.

  1. Remove the instrument panel upper (Click here).



    H044993E02

  1. Release the front side airbag door from the front side hook by slightly bending it and lift out the front passenger airbag rearward.

  1. Release the rear side airbag door from the other hook and remove the front passenger airbag.