IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL TRANSPONDER KEY AMPLIFIER

  1. Connect the connector.

  1. Install the transponder key amplifier.



2. INSTALL STEERING COLUMN COVER


    C128492

  1. Attach the claw to install the upper steering column cover.



    C128491

  1. Attach the 4 claws to install the lower steering column cover.



3. INSTALL STEERING WHEEL ASSEMBLY


    C132123E02

  1. Align the matchmarks and install the steering wheel to the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.



4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


5. INSPECT STEERING WHEEL CENTER POINT


6. INSTALL STEERING PAD ASSEMBLY


B127893E01

  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.



    B130245E02

  1. Using a T30 "torx" driver, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. INSPECT STEERING PAD ASSEMBLY

  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



9. CHECK SRS WARNING LIGHT

  1. Check the SRS warning light (Click here).