NAVIGATION SYSTEM (for HDD) > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here

INSPECTION PROCEDURE

1. Check the radio automatic station search function.
   

   1. Check the radio automatic station search function by activating it.
      

      OK:

      The radio automatic station search function works properly.
      

NG	Go to step 2

OK
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

1. Check for optional components (sun-shade film, telephone antenna, etc.).
   

   1. Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
      

      OK:

      Optional components are installed.
      

      NOTICE:

      Do not remove any optional components installed by the customer without his or her consent.

NG	Go to step 3

OK
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

1. With the ignition switch ON, turn on the radio and choose the AM mode.
   

2. Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.
   

   OK:

   Noise is heard.
   

NG	Go to step 4

OK
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

1. Preparation for check.
   

   1. Remove the antenna connector from the navigation receiver assembly.
      

2. Check for noise.
   

   1. Turn the ignition switch to ACC with the navigation receiver assembly connector connected.
      

   2. Turn the radio on and choose the AM mode.
      

   3. Place a screwdriver, thin wire, or other metal object on the navigation receiver assembly antenna jack and check that noise can be heard from the speaker.
      

      OK:

      Noise occurs.
      

NG	REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)