Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
95
Copyright © 2007 ATSG
3
2
5
5
7
6
2 CONVERTER HOUSING AND OIL PUMP ASSEMBLY
3 CONVERTER HOUSING TO CASE BOLTS (9 REQUIRED)
5 CONVERTER HOUSING TO CASE "O" RING SEAL
6 CONVERTER HOUSING LOCATING DOWEL
7 TRANSMISSION CASE ASSEMBLY
INTERNAL COMPONENTS (CONT'D)
FINAL ASSEMBLY
28. Lay the completed converter housing and oil
pump assembly on flat work surface, as shown
in Figure 166.
29. Install new converter housing to case "O" ring
seal, as shown in Figure 166, and lube with a
small amount of Trans-Jel®.
30. Install the converter housing and oil pump
assembly, as shown in Figure 167.
Note: You may have to turn the turbine shaft
to get the assembly to fully seat, as the stator
shaft must spline into the input sun gear.
31. Ensure that converter housing is fully seated
against case surface and over locating dowel
32. Install the nine (9) converter housing to case
retaining bolts, as shown in Figure 167, finger
tight only at this time.
Continued on Page 96
Copyright © 2007 ATSG
Figure 166 Figure 167
5 CONVERTER HOUSING TO CASE "O" RING SEAL

Leave a Reply

Your email address will not be published. Required fields are marked *