Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
94
Copyright © 2007 ATSG
427 1-2-3-4 AND 3-5 REVERSE CLUTCH HOUSING ASSEMBLY
Figure 164 Figure 165
22. Place the completed 1-2-3-4 and 3-5 reverse
clutch housing on a flat surface, as shown in
Figure 164.
23. Install the DT-47781 clutch assembly installer
over 1-2-3-4 and 3-5 reverse clutch housing, as
shown in Figure 164, and close the vise grip
type clamp.
Note: This tool is also a suggested purchase
as there are three different things to align by
rotating back and forth to install this housing.
24. Grab the entire assembly by the "handles" of
the DT-47781 and install the 1-2-3-4 and 3-5
reverse clutch housing, as shown in Figure 165.
25. Wiggle the DT-47781 back and forth in order
to align the 1-2-3-4 clutch plates, and the 3-5
reverse clutch plates with the external splines
of the two shells. (See Figure 165).
26. There are also splines on the 3-5 reverse clutch
housing that must be engaged into the splines
of the input carrier.
27. To verify that 1-2-3-4 and 3-5 reverse clutch
housing is fully seated, lift up on the turbine
shaft. There should not be any noticeable
end-play..
INTERNAL COMPONENTS (CONT'D)
FINAL ASSEMBLY
Continued on Page 95
427
427
7
DT-47781 CLUTCH
ASSEMBLY INSTALLER
DT-47781 CLUTCH
ASSEMBLY INSTALLER
Copyright © 2007 ATSG
7 TRANSMISSION CASE ASSEMBLY
427 1-2-3-4 AND 3-5 REVERSE CLUTCH HOUSING ASSEMBLY

Leave a Reply

Your email address will not be published. Required fields are marked *