Workshop

HYDRA-MATIC 6L80 (6 Speed)

Copyright © 2007 ATSG
64
65
Figure 157
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
90
67
66
Figure 155
Copyright © 2007 ATSG
J-45126 SNAP RING
PLIERS AND DT-47773
ADAPTER SET
"MANDATORY TOOL"
Figure 156
FINAL ASSEMBLY
6. Install the pre-assembled center support
assembly, as shown in Figure 155.
7. When the center support assembly is properly
installed, the fluid passages should align with
the fluid passage seal bores in the case.
Note: It may be necessary to rotate the output
shaft by hand in order to fully seat the center
support in the case.
8. Install center support retaining ring with the
tapered side facing up, as shown in Figure 155,
and snap ring opening at the 9 o'clock position,
using the J-45126 snap ring pliers along with
DT-47773 adapter set, shown in Figure 156.
Note: This is a mandatory tool for snap ring
installation to prevent bodily injury.
9. Install the thrust bearing on top of the center
support in direction shown in Figure 157.
10. Install the 2-6 and 3-5 reverse clutch hub and
shaft assembly, as shown in Figure 157.
Continued on Page 91
64 2-6 AND 3-5 REVERSE CLUTCH HUB AND SHAFT ASSEMBLY
65 2-6 AND 3-5 REVERSE CLUTCH HUB THRUST BEARING
66 CENTER SUPPORT TO CASE RETAINING SNAP RING
67 CENTER SUPPORT ASSEMBLY
Copyright © 2007 ATSG
INTERNAL COMPONENTS (CONT'D)

Leave a Reply

Your email address will not be published. Required fields are marked *