Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
89
INTERNAL COMPONENTS
FINAL ASSEMBLY
Copyright © 2007 ATSG
LUBRICATE BUSHING
AND REAR SEAL
Figure 153
Copyright © 2007 ATSG
OUTPUT SHAFT AND
REAR PLANETARY
ASSEMBLY
OUTPUT SHAFT TO
CASE THRUST BEARING
DT-47786
LIFTING TOOL
Figure 154
1. Rotate transmission case in fixture so that rear
of preassembled case is facing up, as shown in
Figure 153.
2. Lubricate rear case bushing and rear seal inside
diameters witha small amount of Trans-Jel®,
as shown Figure 153.
3. Install the output shaft to case thrust bearing
into case, in the direction shown in Figure 154.
4. Ensure the DT-47786 lifting tool is completely
threaded into the output shaft assembly, as
shown in Figure 154. Due to the weight of the
assembly, incomplete threading may let the
assembly break free, causing damage/injury.
5. Install the pre-assembled output shaft assembly
into the case, as shown in Figure 154, using the
DT-47786 lifting tool.
Continued on Page 90

Leave a Reply

Your email address will not be published. Required fields are marked *