Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
78
69 REAR CARRIER TO OUTPUT SHAFT THRUST BEARING
490 OUTPUT CARRIER ASSEMBLY
495 OUTPUT CARRIER FRONT INTERNAL RING GEAR
499 OUTPUT SHAFT ASSEMBLY (MODEL SENSITIVE)
495
STEPPED SIDE
FACES UP
AS SHOWN
69
490
Copyright © 2007 ATSG
Copyright © 2007 ATSG
REAR CARRIER AND OUTPUT SHAFT (CONT'D)
18. Place the pre-assembled rear planetary carrier
assembly on flat work surface with the snap
ring side facing down, as shown in Figure 130.
19. Install the output carrier to output shaft thrust
bearing onto carrier in the direction shown in
Figure 130.
20. Install the output carrier front internal ring gear
onto the carrier with the stepped side facing up,
as shown in Figure 130, and engage it with the
bottom set of carrier pinion gears.
Note: Should look like the illustration shown
in Figure 131.
21. Install output shaft assembly over the output
carrier, as shown in Figure 131.
Continued on Page 79
499
Figure 130
Figure 131

Leave a Reply

Your email address will not be published. Required fields are marked *