Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
76
Copyright © 2007 ATSGCopyright © 2007 ATSGCopyright © 2007 ATSG
485
486
487
488
489
THICK SIDE OF
BEARING SHELL
FACES "UP"
491
490
DT-47857
ROLLER
BEARING
ASSEMBLY
485 CAGED ROLLER BEARING ASSEMBLY
486 OUTPUT CARRIER FRONT SUN GEAR THRUST BEARING
487 OUTPUT CARRIER FRONT SUN GEAR
488 OUTPUT CARRIER FRONT SUN GEAR REAR THRUST BEARING
489 OUTPUT CARRIER REAR SUN GEAR
490 OUTPUT CARRIER ASSEMBLY
491 OUTPUT CARRIER REAR SUN GEAR THRUST BEARING
(THIS IS A "CAPTURED" BEARING AND NOT SERVICED)
REAR CARRIER AND OUTPUT SHAFT (CONT'D)
8. Install output carrier rear sun gear, as shown in
Figure 126.
9. Install rear sun gear rear thrust bearing in the
direction shown in Figure 126.
10. Install the front sun gear in carrier, as shown in
Figure 126.
11. Install front sun gear front thrust bearing in the
direction shown in Figure 126.
12. Install a new caged roller bearing using proper
driver, as shown in Figure 127, and ensure the
thick side of bearing is facing up.
Continued on Page 77
Figure 126 Figure 127

Leave a Reply

Your email address will not be published. Required fields are marked *