Workshop

HYDRA-MATIC 6L80 (6 Speed)

REAR PLANETARY CARRIER AND OUTPUT SHAFT EXPLODED VIEW
494 494
490
495 496
497
498
499
69
71
69 REAR CARRIER TO OUTPUT SHAFT THRUST BEARING
71 OUTPUT SHAFT TO CASE THRUST BEARING
490 OUTPUT CARRIER ASSEMBLY
494 RETAINING SNAP RING (2 REQUIRED)
495 OUTPUT CARRIER FRONT INTERNAL RING GEAR
496 OUTPUT CARRIER INTERNAL RING GEAR SPACER
497 OUTPUT CARRIER REAR INTERNAL RING GEAR
498 OUTPUT SHAFT BUSHING
499 OUTPUT SHAFT ASSEMBLY (MODEL SENSITIVE)
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
73
Copyright © 2007 ATSG
COMPONENT REBUILD
REAR CARRIER AND OUTPUT SHAFT
1. Disassemble the output shaft assembly using
Figure 122 as a guide.
2. Clean all output shaft parts thoroughly and dry
with compressed air.
3. Inspect all output shaft parts thoroughly for any
wear and/or damage. Replace as necessary.
4. There are currently three different versions of
the output shaft depending on model and all 3
are illustrated and identified in Figure 123.
Figure 122
Continued on Page 75

Leave a Reply

Your email address will not be published. Required fields are marked *