Workshop

HYDRA-MATIC 6L80 (6 Speed)

459
461
462
465
463
464
461 LOW AND REVERSE CLUTCH BACKING PLATE SNAP RING
462 LOW AND REVERSE CLUTCH BACKING PLATE
463 LOW AND REVERSE FRICTION PLATES (5 REQUIRED)
464 LOW AND REVERSE STEEL PLATES (5 REQUIRED)
465 LOW AND REVERSE "WAVE" PLATE
459 CENTER SUPPORT ASSEMBLY
Ensure that snap
ring is fully seated.
Apply air pressure, regulated to 60 psi, to verify
proper installation of all Low/Reverse clutch
components, as there are NO selectives.
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
70
Copyright © 2007 ATSGCopyright © 2007 ATSG
CENTER SUPPORT ASSEMBLY (CONT'D)
Continued on Page 71
23. Install the low/reverse clutch "wave" plate, as
shown in Figure 116.
24. Install the low/reverse clutch plates beginning
with a steel plate and alternating with a friction
plate until you have installed five of each, as
shown in Figure 116.
25. Install the low/reverse clutch backing plate, as
shown in Figure 116.
26. Install the low/reverse clutch backing plate
snap ring, as shown in Figure 116.
27. There are no selectives for the low/reverse
clutch pack. You should have approximately
.050" clearance. If you do not, you have
mis-built the low/reverse clutch and you must
do it again.
28. Ensure that the snap ring is fully seated and air
check the low/reverse clutch to verify integrity,
as shown in Figure 117.
Figure 116 Figure 117

Leave a Reply

Your email address will not be published. Required fields are marked *