Workshop

HYDRA-MATIC 6L80 (6 Speed)

450 2-6 CLUTCH BACKING PLATE SNAP RING
451 2-6 CLUTCH BACKING PLATE
452 2-6 CLUTCH FRICTION PLATES (5 REQUIRED)
453 2-6 CLUTCH STEEL PLATES (5 REQUIRED)
454 2-6 CLUTCH "WAVE" PLATE
459 CENTER SUPPORT ASSEMBLY
459
450
451
454
452
453
Ensure that snap
ring is fully seated.
Apply air pressure regulated to 60 psi, to verify
proper installation of all 2-6 clutch components,
as there are NO selectives.
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
67
Copyright © 2007 ATSGCopyright © 2007 ATSG
Figure 109 Figure 110
CENTER SUPPORT ASSEMBLY (CONT'D)
9. Install the 2-6 clutch "wave" plate into center
support, as shown in Figure 109.
10. Install the 2-6 clutch plates beginning with a
steel plate and alternating with a friction plate
until you have installed five of each, as shown
in Figure 109.
11. Install the 2-6 clutch backing plate, as shown
in Figure 109.
12. Install the 2-6 clutch backing plate snap ring,
as shown in Figure 109.
13. There are no selectives for the 2-6 clutch pack.
You should have approximately .050" clutch
clearance. If you do not, you have mis-built
the 2-6 clutch and you must do again.
14. Ensure that the snap ring is fully seated and air
check the 2-6 clutch to verify integrity, as
shown in Figure 110.
Continued on Page 68

Leave a Reply

Your email address will not be published. Required fields are marked *