Workshop

HYDRA-MATIC 6L80 (6 Speed)

404
402
403
401
400
400 3-5 REVERSE CLUTCH BACKING PLATE SNAP RING
401 3-5 REVERSE CLUTCH BACKING PLATE
402 3-5 REVERSE CLUTCH FRICTION PLATES
403 3-5 REVERSE CLUTCH STEEL PLATES
404 3-5 REVERSE CLUTCH "WAVED" PLATE
405 3-5 REVERSE CLUTCH APPLY RING
405
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
61
Copyright © 2007 ATSGCopyright © 2007 ATSG
1-2-3-4 AND 3-5 REVERSE HOUSING (CONT'D)
29. Install the 3-5 reverse clutch apply ring with
legs going down between the 1-2-3-4 backing
plate and the housing, as shown in Figure 100.
30. Install the 3-5 reverse clutch "wave" plate on
top of the apply ring, as shown in Figure 101.
31. Install the 3-5 reverse clutch plates beginning
with a steel plate and alternating with a friction
plate until you have installed four of each, as
shown in Figure 101.
32. Install the 3-5 reverse clutch backing plate, as
shown in Figure 101.
33. Install the 3-5 reverse clutch backing plate
selective snap ring, as shown in Figure 101.
Note: The snap ring opening must be aligned
with the missing snap ring groove punch in
the housing, as shown in Figure 102.
Continued on Page 62
Figure 100 Figure 101

Leave a Reply

Your email address will not be published. Required fields are marked *