Workshop

HYDRA-MATIC 6L80 (6 Speed)

423
SMALL LIPS
FACING IN
424
425
427
423
424
425
423 1-2-3-4 CLUTCH PISTON INNER SEAL
424 1-2-3-4 CLUTCH PISTON HOUSING SEAL
425 1-2-3-4 CLUTCH PISTON HOUSING SEAL
415
417
421
427
420
415 1-2-3-4 CLUTCH PISTON HOUSING SNAP RING
417 1-2-3-4 CLUITCH APPLY PISTON HOUSING AND SEALS
420 3-5 REVERSE CLUTCH APPLY PISTON "BELLVILLE" SPRING
421 3-5 REVERSE CLUTCH APPLY PISTON AND SEALS
427 3-5 REVERSE CLUTCH HOUSING ASSEMBLY
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
58
Copyright © 2007 ATSGCopyright © 2007 ATSG
1-2-3-4 AND 3-5 REVERSE HOUSING (CONT'D)
9. Install only the two "O" ring seals into their
grooves in the 1-2-3-4 and 3-5 reverse housing
hub, as shown in Figure 94.
Note: "Do Not" install the 1-2-3-4 clutch
inner seal in the top groove at this time. We
will install this seal "After" we have installed
the snap ring for the 3-5 reverse piston.
Figure 94 Figure 95
10. Lubricate the outer seal and both inner seal
surfaces of the 3-5 reverse piston assembly,
as shown in Figure 95.
Continued on Page 59

Leave a Reply

Your email address will not be published. Required fields are marked *