Workshop

HYDRA-MATIC 6L80 (6 Speed)

212
214
213
211
209
215
210
203 TORQUE CONVERTER HOUSING (MODEL DEPENDENT)
209 OIL PUMP SLIDE SEAL RING
210 OIL PUMP SLIDE BACK-UP "O" RING SEAL
211 OIL PUMP SLIDE RETURN SPRING
212 OIL PUMP SLIDE (SELECTIVE)
213 OIL PUMP SLIDE TEFLON SEAL
214 OIL PUMP SLIDE TEFLON SEAL SUPPORT
215 OIL PUMP SLIDE PIVOT PIN AND SPRING ASSEMBLY
214
213
209
210
203
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
46
Copyright © 2007 ATSG
Figure 69 Figure 70
OIL PUMP ASSEMBLY (CONT'D)
28. Install the pump slide pivot pin and spring, as
shown in Figure 69.
29. Install oil pump slide back-up "O" ring (210)
and pump slide seal ring (209) into groove in
pump slide, as shown in Figure 69, and retain
with a small amount of Trans-Jel®.
30. Install the oil pump slide into the pump pocket,
as shown in Figure 69, with the seal ring (209)
facing down.
31. Install the oil pump slide "Teflon" seal (213) by
pulling the slide toward the pump pivot pin and
sliding the seal down between the slide seal
support (214) and converter housing, as shown
in Figure 69.
32. Install the oil pump slide spring, as shown in
Figure 69, using a screwdriver or installation
tool.
33. Install the oil pump rotor guide into the rotor
in the direction shown in Figure 70, and retain
with a small amount of Trans-Jel®.
Note: Align the rotor guide tabs to notches
on the bottom of rotor (See Figure 70).
217 OIL PUMP ROTOR (SELECTIVE)
208 OIL PUMP ROTOR GUIDE
Copyright © 2007 ATSG
208
217
Continued on Page 47

Leave a Reply

Your email address will not be published. Required fields are marked *