Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
40
Copyright © 2007 ATSG
Copyright © 2007 ATSG
REAR CASE SEAL
REAR CASE PLUGS
J-38693
SEAL INSTALLER
Copyright © 2007 ATSG
PARKING PAWL
ACTUATOR GUIDE
"O" RING SEALS
RETAINING PIN
COMPONENT REBUILD
TRANSMISSION CASE ASSEMBLY (CONT'D)
7. Remove park pawl actuator guide retaining
pin and actuator guide, as shown in Figure 56.
8. Remove and discard the park pawl actuator
guide "O" rings.
9. Install new park pawl actuator guide "O" rings
and lube with a small amount of Trans-Jel®.
10. Install the park pawl actuator guide, as shown
in Figure 56, ensuring you do not damage the
"O" ring seals.
11. Install the actuator guide retaining pin into the
case, as shown in Figure 56.
12. Install new rear case seal using seal installer,
as shown in Figure 57.
13. Install new case plugs as necessary, as shown
in Figure 58.
Componet Rebuild
Continued on Page 41
Figure 56 Figure 58
Figure 57

Leave a Reply

Your email address will not be published. Required fields are marked *