Workshop

HYDRA-MATIC 6L80 (6 Speed)

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
35
Copyright © 2007 ATSG
Copyright © 2007 ATSG
7
51
56
7 TRANSMISSION CASE ASSEMBLY
51 1-2-3-4 AND 3-5 REVERSE CLUTCH ASSEMBLY
56 4-5-6 CLUTCH HOUSING ASSEMBLY, W/TURBINE SHAFT
INTERNAL PARTS (CONT'D)
7. Remove the 4-5-6 Clutch Housing and the 3-5
Reverse Clutch drum as a complete assembly
by lifting straight up using the turbine shaft, as
shown in Figure 45.
8. Seperate all components removed, as shown in
Figure 46, and set aside for component rebuild
section.
9. Remove the 4-5-6 clutch hub and dampener
assembly and thrust bearing, as shown in
Figure 47.
10. Set the 4-5-6 clutch hub and the dampener
assembly aside for component rebuild section.
11. Remove both clutch hub and shaft assemblies,
all 3 bearings, as shown in Figure 48, and set
aside for the component rebuild section.
Continued on Page 36
51 1-2-3-4 AND 3-5 REVERSE CLUTCH HOUSING ASSEMBLY
52 INPUT PLANETARY CARRIER ASSEMBLY
53 INPUT SUN GEAR
54 INPUT SUN GEAR THRUST BEARING (SNAPS IN PLACE)
55 INPUT PLANETARY CARRIER THRUST WASHER
56 4-5-6 CLUTCH HOUSING ASSEMBLY
51
52
53
54
55
56
Figure 45
Figure 46
Figure 47
Copyright © 2007 ATSG
57
58
57 4-5-6 CLUTCH HUB TO TURBINE SHAFT THRUST BEARING
58 4-5-6 CLUTCH HUB AND DAMPENER ASSEMBLY

Leave a Reply

Your email address will not be published. Required fields are marked *