Workshop

HYDRA-MATIC 6L80 (6 Speed)

Copyright © 2007 ATSGCopyright © 2007 ATSG
TECKPAK
FITZ-ALL
10.9
10.9
10.9
10.9
3
2
5
7
2 CONVERTER HOUSING AND OIL PUMP ASSEMBLY
3 CONVERTER HOUSING TO CASE BOLTS (9 REQUIRED)
5 CONVERTER HOUSING TO CASE "O" RING SEAL
7 TRANSMISSION CASE ASSEMBLY
INTERNAL PARTS
TRANSMISSION DISASSEMBLY
1. Rotate the transmission so that the converter
housing is facing up, as shown in Figure 44.
2. Remove the "O" ring from the turbine shaft,
as shown in Figure 43.
3. Remove the nine converter housing to case
bolts, as shown in Figure 44.
Note: There are no washers on these bolts.
4. Remove the converter housing and oil pump
assembly, as shown in Figure 44.
5. Remove and discard the converter housing to
case "O" ring seal, as shown in Figure 44.
6. Set the converter housing/oil pump assembly
aside for component rebuild section.
Continued on Page 35
Figure 43 Figure 44
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
34
10.9
10.9
10.9
10.9
10.9

Leave a Reply

Your email address will not be published. Required fields are marked *