Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
98
Copyright © 2002 ATSG
559
560
562
563
30
30 DRIVESHAFT YOKE TO OUTPUT SHAFT SPACER
559 OUTPUT SHAFT TO PL ANETARY CARRIER THRUST BEARING
560 5L40-E REAR INTERNAL RING GEAR
562 5L40-E OUTPUT SHAFT ASSEMBLY
563 OUTPUT SHAFT TO RING GEAR RETAINING SNAP RING
5L40-E OUTPUT SHAFT EXPLODED VIEW"5L40-E" PLANETARY SYSTEM (CONT'D)
Copyright © 2002 ATSG
COMPLETED 5L40-E OUTPUT SHAFT
Figure 157 Figure 158
13. Install output shaft into the output internal ring
gear, as shown in Figure 158.
14. Install the internal ring gear snap ring into the
groove in ring gear, as shown in Figure 158,
and ensure that it is fully seated.
15. Install driveshaft yoke spacer onto output shaft
against the flat surface (See Figure 158).
16. Install thrust bearing (559) onto output shaft,
as shown in Figure 158, and retain with small
amount of Trans-Jel®.
17. Set the completed 5L40-E output shaft, as
shown in Figure 157, aside for the final
transmission assembly process.

Leave a Reply

Your email address will not be published. Required fields are marked *