Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

512 LOW/REVERSE CLUTCH "INNER SPLINE" PLATE (5)
513 LOW/REVERSE CLUTCH "OUTER SPLINE" PLATE (5)
518 CENTER SUPPORT ASSEMBLY
510 LOW/REVERSE CLUTCH BACKING PLATE SNAP RING
511 LOW/REVERSE CLUTCH BACKING PLATE
518 CENTER SUPPORT ASSEMBLY
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
86
Copyright © 2002 ATSGCopyright © 2002 ATSG
513
512
518
518
511
510
Figure 136 Figure 137
CENTER SUPPORT (CONT'D)
11. Install low/reverse clutch "single sided" plates
beginning with an outside spline plate first and
alternating with inside spline plates until you
have installed 5 of each (See Figure 136).
Note: Lined side must be installed facing up,
as shown in Figure 136. Clutch plate
amounts may vary by model.
12. Install the low/reverse backing plate, as shown
in Figure 137.
13. Install the "Selective" backing plate snap ring,
as shown in Figure 137, and ensure that snap
ring is fully seated against the top of snap ring
groove in the center support.

Leave a Reply

Your email address will not be published. Required fields are marked *