Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
71
Copyright © 2002 ATSG
470 OVERDRIVE CLUTCH HUB ASSEMBLY
471 INTERMEDIATE SPRAG FRONT THRUST WASHER
472 INTERMEDIATE SPRAG END BEARINGS (2 REQUIRED)
470
471
472
Copyright © 2002 ATSG
INTERMEDIATE SPRAG
OUTER RACE
INTERMEDIATE SPRAG
AND CAGE ASSEMBLY
"WINDOWS" TO LEFT
AS SHOWN
Figure 107 Figure 108
6. Place the overdrive clutch hub on a flat surface
with shaft facing up, as shown in Figure 107.
7. Install intermediate sprag outer race thrust
washer, as shown in Figure 107.
8. Install one intermediate sprag end bearing on
top of the thrust washer in the direction shown
in Figure 107.
9. Install the intermediate sprag cage assembly in
the outer sprag race exactly as shown in Figure
108, with the "windows" to the left, and ensure
that the outer race is arranged as shown. Refer
to Figure 108.
Continued on Page 72
O.D. CLUTCH HUB/INTERMEDIATE SPRAG (CONT'D)

Leave a Reply

Your email address will not be published. Required fields are marked *