Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

464 OUTER RACE TO DIRECT DRUM THRUST WASHER
466 DIRECT CLUTCH HUB AND SHAFT ASSEMBLY
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
69
Copyright © 2002 ATSG
466
464
COMPONENT REBUILD COMPONENT REBUILD
DIRECT CLUTCH HUB AND WASHER O.D. CLUTCH HUB/INTERMEDIATE SPRAG
1. Install the direct clutch hub to forward sprag
outer race thrust washer into the direct clutch
hub and shaft assembly in the direction shown
in Figure 104, and retain with a small amount
of Trans-Jel®.
2. Set the completed assembly aside for the final
transmission assembly process.
1. Place the overdrive clutch hub and intermediate
sprag assembly on flat work surface, as shown
in Figure 105.
2. The intermediate sprag outer race is held on
with a pressed on metal retainer, as shown in
Figure 105, and can be removed easily with 2
screwdrivers as shown in Figure 105.
3. After removing the metal retainer dis-assemble
the remainder of the intermediate sprag using
Figure 106 as a guide.
4. Clean all intermediate sprag parts thoroughly
and dry with compressed air.
5. Inspect all intermediate sprag parts thoroughly
for any wear and/or damage.
Figure 104 Figure 105
U
E
N
T
T
E
A
D
P
F
R
A
N
F
C
E
K
S
3
7
2
6
4
4
B
E
W
F
Copyright © 2002 ATSG
REMOVING INTERMEDIATE SPRAG ASSEMBLY
THRUST BEARING RETAINER
Continued on Page 70

Leave a Reply

Your email address will not be published. Required fields are marked *