Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
118
BOTTOM PAN COMPONENTS
TRANSMISSION ASSEMBLY (CONT'D)
1. Install the input shaft speed sensor, as shown
in Figure 197.
2. Torque the input shaft speed sensor bolt down
to 11 Nm (8 ft.lb.).
Note: Refer to the bolt chart to identify the
proper bolt.
3. Install the output shaft speed sensor, as shown
in Figure 198.
4. Torque the output shaft speed sensor bolt down
to 11 Nm (8ft.lb.).
Note: Refer to the bolt chart to identify the
proper bolt.
5. Install the pre-assembled valve body assembly
onto case, as shown in Figure 199.
6. Install the proper bolts installed in the locations
shown in Figure 199 and 201, and hand tighten
only at this time.
Note: Refer to the bolt chart to identify the
proper valve body bolts.
7. Install a 0.8 mm spacer between inside detent
lever and the detent spring, as shown in Figure
200.
8. Torque all ten valve body bolts, in the exact
sequence shown in Figure 201, down to
11 Nm (8 ft.lb.).
9. Remove the 0.8 mm spacer.
Continued on Page 120
44 INPUT SHAFT SPEED SENSOR
45 INPUT SPEED SENSOR RETAINING BOLT
Copyright © 2002 ATSG
Copyright © 2002 ATSG
41 OUTPUT SPEED SENSOR SPACER
42 OUTPUT SHAFT SPEED SENSOR
43 OUTPUT SPEED SENSOR RETAINING BOLT
41
42
44
45
43
Figure 197
Figure 198

Leave a Reply

Your email address will not be published. Required fields are marked *