Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
116
Copyright © 2002 ATSG Copyright © 2002 ATSG
INTERNAL COMPONENTS (CONT'D)
TRANSMISSION ASSEMBLY (CONT'D)
27. Install the molded pump to case gasket (46)
onto the back side of pump cover, as shown in
Figure 192, using the molded guide pins.
28. Retain with a small amount of Trans-Jel®, if
necessary.
29. Install complete converter housing assembly
onto case, as shown in Figure 192.
30. Install the seven converter housing to case
bolts, as shown in Figure 192. Refer to the bolt
chart to identify proper bolts.
31. Torque the seven bolts to 22 Nm (16 ft,lb.),
as shown in Figure 194.
32. Use the torque sequence in a cris-cross pattern,
as shown in Figure 193.
33. Install the turbine shaft "O" ring seal using a
small screwdriver, as shown in Figure 195, and
lubricate with small amount of Trans-Jel®.
2 BELL HOUSING RETAINING BOLTS (7 REQUIRED)
3 BELL HOUSING AND PUMP ASSEMBLY
4 BELL HOUSING TO CASE SEAL
46
2
3
4
Figure 192 Figure 193
1
2
3
4
5
6
7
CONVERTER HOUSING
TORQUE SEQUENCE

Leave a Reply

Your email address will not be published. Required fields are marked *