Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
111
Copyright © 2002 ATSGCopyright © 2002 ATSG
Figure 183Figure 182
14
J-45126
14 INTERM/O.D. CLUTCH HOUSING SNAP RING (SELECTIVE)
Snap Ring Pliers J-45126 Are "Required"
To Remove Or Replace This Snap Ring
Snap Ring Pliers J-45126 are long
handled for leverage and locking
10. After you have both dimensions recorded,
subtract "M1" from "M2".
Note: This will be Dimension "M".
11. Refer to the chart in Figure 181 to determine
the thickness of the proper snap ring.
12. Measure thickness of your snap ring exactly
as shown in Figure 182, to ensure that your
snap ring is the proper thickness.
INTERNAL COMPONENTS (CONT'D)
Measure Snap Ring
Thickness
EXAMPLE:
1. Dimension "M1" = 4.206".
2. Dimension "M2" = 4.249".
3. Subtract "M1" from "M2" = .043".
4. Dimension "M" = .043"
5. Dimension "M" from the chart in Figure
181 shows a .141"-.145" thickness snap
ring required.
13. Now you can install the proper size snap ring
using the J-45126 snap ring pliers, as shown in
Figure 183.
Note: This snap ring is "Very" strong and
requires J-45126 snap ring pliers to
avoid any possible injury.
Continued on Page 112

Leave a Reply

Your email address will not be published. Required fields are marked *