Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
109
16
17
18 CENTER SUPPORT ASSEMBLY
16 LOW SPRAG ASSEMBLY
17 LOW SPRAG TO CENTER SUPPORT THRUST WASHER
6. Install pre-assembled intermediate/overdrive
clutch housing, as shown in Figure 178. Rotate
the output shaft back and forth until it is fully
seated and engaged on the low sprag race.
7. "Do Not" install the snap ring yet. This snap
ring is "Selective" and we must measure to
determine correct thickness.
INTERNAL COMPONENTS
TRANSMISSION ASSEMBLY (CONT'D)
Copyright © 2002 ATSG
Copyright © 2002 ATSG
18
Figure 176
Figure 177
Copyright © 2002 ATSG
Figure 178
14
15
14 INTERM/O.D. CLUTCH HOUSING SNAP RING (SELECTIVE)
15 INTERMEDIATE/OVERDRIVE CLUTCH HOUSING ASSEMBLY
Continued on Page 110

Leave a Reply

Your email address will not be published. Required fields are marked *