Workshop

HYDRA – MATIC 4L40 – E / 5L40 – E

Copyright © 2002 ATSG
310
311
J-39068 VALVE
BODY GUIDE PINS
(4 REQUIRED)
309
307
308
312
307 VALVE BODY SPACER PLATE
308 TCC PWM SOLENOID SCREEN ASSEMBLY
309 LOWER SPACER PLATE GASKET
310 REAR VALVE BODY ASSEMBLY
311 FRONT VALVE BODY ASSEMBLY
312 PRESSURE CONTROL SOLENOID SCREEN ASSEMBLY
304 BOTTOM CHANNEL PL ATE WITH CHECKBALLS INSTALLED
305 UPPER SPACER PLATE GASKET
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
104
Copyright © 2002 ATSG
305
304
VALVE BODY ASSEMBLY (CONT'D)
19. Lay both front and rear valve body assemblies
on a flat work surface exactly as they are layed
out in Figure 166.
20. Install the four J-39068 guide pins in locations
shown in Figure 166.
21. Install two new screens into the spacer plate in
locations shown in Figure 166.
22. Install lower spacer plate gasket over the guide
pins as shown in Figure 166.
23. Install spacer plate over guide pins, as shown
in Figure 166.
24. Install upper spacer plate gasket over the guide
pins, as shown in Figure 167.
25. Install valve body checkballs into their proper
locations in the lower channel plate, as shown
in Figure 168.
Note: Retain the checkballs in channel plate
with "Small" amount of Trans-Jel®.
26. Install the lower channel plate with checkballs
over the guide pins, as shown in Figure 167.
Figure 166 Figure 167
Continued on Page 107

Leave a Reply

Your email address will not be published. Required fields are marked *