Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
99
Copyright © 2004 ATSG
Figure 175
Frdo
GA8
6540
R3 9 A1
5
6 3 8
T A
R3 9
C 0A
o
rF d
-6 2 1
-6 2 1
OIL FILTER
RETAINING BOLTS
(82mm LENGTH)
Copyright © 2004 ATSG
Figure 176
Ford
GA8
640
5
3 19 AR
6538
T9 R3 A
CA 0
Ford
216 -216 -
PAN GASKET
PAN BOLTS
(16 REQUIRED)
INTERNAL COMPONENTS (Cont'd)
79. Install new filter seals on new filter and install
filter assembly, as shown in Figure 175.
80. Torque both filter bolts to 10 N•m (89 in.lb.).
81. Install new pan gasket onto transmission case,
as shown in Figure 176.
Note: The bottom pan gasket is reuseable.
Clean and inspect the gasket for damage, and
if it is not damaged, it may be re-used.
82. Install the bottom pan assembly and the sixteen
bottom pan bolts, as shown in Figure 176, and
torque pan bolts to 11 N•m (8 ft.lb.) using the
criss-cross pattern.
83. Rotate transmission in fixture so that the rear
is facing up, as shown in Figure 177.
84. Remove the output shaft holding strap if you
have not already done so (See Figure 177).
Continued on Page 100
74. Install the pre-checked solenoid body assembly
onto transmission, as shown in Figure 174, and
finger tighten only at this time.
Caution: Use small amount of Trans-Jel® on
solenoid body connector "O" rings to help
prevent damage.
75. Install pre-assembled reverse servo assembly
onto spacer plate, as shown in Figure 174, and
finger tighten only at this time.
76. Torque all of the valve body bolts to 10 N•m
(89 in.lb.), beginning in the center and working
outward in a circle.
77. Torque all of the solenoid body bolts to 8 N•m
(71 in.lb.), using a criss-cross pattern.
78. Torque all of the reverse servo bolts to 10 N•m
(89 in.lb.), using a criss-cross pattern.

Leave a Reply

Your email address will not be published. Required fields are marked *