Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
97
VALVE BODY
RETAINING BOLT
"1" REQUIRED
(45mm LENGTH)
THE REMAINING 18
VALVE BODY BOLTS
ARE 40mm LENGTH
VALVE BODY
RETAINING BOLT
"1" REQUIRED
(27mm LENGTH)
Valve
Body
(18)
(40mm)
8 mm
Detent
Spring
(1)
(30mm)
8 mm
Valve
Body
(1)
(27mm)
8 mm
Valve
Body
(1)
(45mm)
8 mm
VALVE BODY BOLT IDENTIFICATION
Copyright © 2004 ATSG
INTERNAL COMPONENTS (Cont'd)
Figure 172
Figure 173
Shown
Actual Size
67. Install the two valve body alignment dowels
in the locations shown in Figure 171.
68. Install the pre-assembled valve body and spacer
plate, as shown in Figure 171.
Caution: Ensure that manual valve is engaged
on the inside detent lever properly.
69. There are four different lengths of valve body
bolts, as shown in Figure 172.
70. Install the 27mm length bolt finger tight only,
in the location shown in Figure 173.
71. Install the 45mm length bolt finger tight only,
in the location shown in Figure 173.
72. Install the remaining 18, 40mm length valve
body bolts, in locations shown in Figure 173,
and finger tighten only at this time.
73. Install the detent spring assembly, as shown in
Figure 171, using the only 30mm length bolt,
and finger tighten only at this time.
Continued on Page 99

Leave a Reply

Your email address will not be published. Required fields are marked *