Workshop

FORD 5R55S/5R55W

Figure 169
Ford
GA8
6540
R3 19 A
6538
R3 T9 A
CA 0
Ford
Copyright © 2004 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
95
TORQUE CENTER SUPPORT BOLT
TO 11 Nm (100 in.lb.)
INTERMEDIATE BAND
ADJUSTING SCREW
OVERDRIVE BAND
ADJUSTING SCREW
Figure 170
Ford
Copyright © 2001 ATSG
INTERNAL COMPONENTS (Cont'd)
63. Install new locking nuts on both band adjusting
screws, using care not to let the adjusting screw
come out, so that the band anchors will not fall
out and into transmission (See Figure 170).
64. Adjust the overdrive band by turning adjusting
screw in while holding the lock nut. Torque
the adjusting screw to 14 Nm (10 ft.lb.) and
then back out exactly 2 full turns for W/S
models in trucks and 1-1/2 turns for S models
in cars. Refer to Figure 170.
65. Adjust intermediate band by turning adjusting
screw in while holding the lock nut. Torque
the adjusting screw to 14 Nm (10 ft.lb.) and
then back out exactly 2 full turns for W/S
models in trucks and 1-1/2 turns for S models
in cars. Refer to Figure 170.
66. Torque both locking nuts to 54 N•m (40 ft.lb.),
while holding adjusting screw.
Continued on Page 97

Leave a Reply

Your email address will not be published. Required fields are marked *