Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
94
Copyright © 2004 ATSG
Figure 168
Copyright © 2004 ATSG
X
W
9
9
4
/
P
1
0
-
7
/
L
9
0
6
6
-
9
A
B
OIL PUMP ASSEMBLY
RETAINING BOLTS
(8 REQUIRED)
OIL PUMP
ASSEMBLY
OIL PUMP
TO CASE
GASKET
8
9
Figure 167
INTERNAL COMPONENTS (Cont'd)
54. Install the oil pump to case gasket into case, as
shown in Figure 167, and align holes.
55. Lubricate the case bore where the "O" ring
rides with a small amount of Trans-Jel®.
56. Install the pre-assembled oil pump assembly
into the case, as shown in Figure 167, using
care not to damage the pump "O" ring.
57. Install the eight oil pump assembly retaining
bolts, and torque to 25Nm (18 ft.lb.), as shown
in Figure 168.
58. Rotate the transmission so that the valve body
surface is facing up, as shown in Figure 169.
59. Torque the center support retaining bolt down
to 11 Nm (100 in.lb.), (See Figure 169).
TORQUE PUMP BOLTS
TO 25 Nm (18 ft.lb.)
Continued on Page 95

Leave a Reply

Your email address will not be published. Required fields are marked *