Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
88
Continued on Page 92
INTERNAL COMPONENTS (Cont'd)
42. Install the center shaft to center support thrust
bearing (No. 3) onto the center support, as
shown in Figure 156.
43. Install the pre-assembled overdrive carrier and
center shaft assembly, as shown in Figure 157,
ensuring that it is splined into the forward
clutch housing and fully seated.
Figure 156
CENTER SHAFT
THRUST BEARING
(NO. 3)
Copyright © 2004 ATSG
COAST CLUTCH
DRUM ADAPTER
OVERDRIVE
SUN GEAR
7
6
6
-
0
P
-
4
A
W
A
X
4
X
4
A
B
Figure 157
OVERDRIVE CARRIER
AND CENTER SHAFT
ASSEMBLY
Copyright © 2004 ATSG
Caution: There are two different overdrive ratios for
this unit, 0.75 and 0.71. This will affect the
overdrive carrier, overdrive ring gear, overdrive sun
gear, overdrive sun gear adapter plate and the coast
clutch housing.
For overdrive planetary carrier identification refer
to Figure 158.
For overdrive planetary ring gear identification
refer to Figure 159.
For overdrive sun gear and sun gear adapter plate
identification refer to Figure 160.
For the coast clutch housing identification refer to
Figure 161.
44. Install the overdrive sun gear into overdrive
carrier, as shown in Figure 157, by rotating
into position.
45. Install the coast clutch housing adapter plate
on overdrive sun gear, as shown in Figure 157,
and ensure that it is fully seated.
NONE OF THE PARTS LISTED ABOVE ARE
COMPATABLE WITH ONE ANOTHER

Leave a Reply

Your email address will not be published. Required fields are marked *