Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
87
MEASURING DIMENSION "B"
SELECTIVE NO. 4 THRUST BEARING CHART
PART NO. I.D. NOTCHES
I.D. NOTCHES
THICKNESS
Figure 153
"TAPERED"
SNAP RING
CENTER SUPPORT
ASSEMBLY
CASE
Copyright © 2004 ATSG
CENTER
SUPPORT
DIAL
CALIPER
NO. 4
SELECTIVE
THRUST
BEARING
Figure 155
Figure 154
4321
1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9
5 6
10 20 30 40 50 60 70 80 90 150140130120110100
0
in
mm
ELECTRONIC
DIGITAL CALIPER
AUTO POWER-OFFAUTO POWER-OFF
mm/inmm/in 00
00.735
IN
Copyright © 2004 ATSG
Checking For End
Clearance Here
Continued on Page 88
.104" - .110"
.111" - .117"
.118" - .125"
.126" - .132"
XW4Z-7D014-CA
XW4Z-7D014-DA
XW4Z-7D014-EA
XW4Z-7D014-FA
None
One
Two
Three
INTERNAL COMPONENTS (Cont'd)
38. Install the center support snap ring with the
opening in the snap ring to the opening in the
center support, as shown in Figure 153.
39. Now we must once again measure with the dial
caliper through the speed sensor hole down to
the surface of the direct clutch housing with all
of the parts installed in the case, as shown in
Figure 155, and record this as dimension "B".
40. Subtract previously recorded dimension "A"
from now recorded dimension "B", and this
will give you the rear end clearance.
Example: Dimension "B" = .735"
Dimension "A" = .725"
Difference = .010"
41. Rear end clearance should be .008" to .012".
Change the selective No. 4 thrust bearing using
the chart in Figure 154, as necessary to arrive
at the proper end play.

Leave a Reply

Your email address will not be published. Required fields are marked *