Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
84
INTERNAL COMPONENTS (Cont'd)
Continued on Page 86
FORWARD CLUTCH
THRUST BEARING
(NO. 5)
FORWARD CLUTCH
THRUST BEARING
(NO. 6A)
Figure 146
FORWARD CLUTCH
DRUM ASSEMBLY
Copyright © 2004 ATSG
CENTER
SUPPORT
DIAL
CALIPER
DIRECT
CLUTCH
HOUSING
NO. 4
SELECTIVE
THRUST
BEARING
Figure 147
96
M 07
1624
4321
1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9
5 6
10 20 30 40 50 60 70 80 90 150140130120110100
0
in
mm
ELECTRONIC
DIGITAL CALIPER
AUTO POWER-OFFAUTO POWER-OFF
mm/inmm/in 00
00.725
IN
Copyright © 2004 ATSG
30. Assemble the selective bearing, direct clutch
housing and center support, on the bench, as
shown in Figure 147.
31. Measure with a dial caliper through the speed
sensor hole down to the surface of the direct
clutch housing, as shown in Figure 147, and
record this as dimension "A".
32. After you have recorded the first measurment,
install the pre-assembled direct clutch housing,
as shown in Figure 148.
33. Install the number 4 thrust bearing in position
on the direct clutch drum, in the direction that
is shown in Figure 148.
34. Install the intermediate band into transmission
and around the direct clutch housing, as shown
in Figure 149.
35. Install the intermediate band struts on each side
of the band exactly as shown in Figure 150.
26. Install forward clutch thrust bearing (No 6A)
onto the back side of pre-assembled forward
clutch drum, in direction shown in Figure 146,
and retain with a small amount of Trans-Jel®.
27. Install forward clutch thrust bearing (No 5) on
front side of forward clutch drum, in direction
shown in Figure 146, and retain with a small
amount of Trans-Jel®.
28. Install forward clutch housing, with bearings,
as an assembly, as shown in Figure 146.
29. Caution: The thrust bearing (No 4) that goes
between direct clutch drum and center support
is "Selective" and a measurement must be
made before installation.

Leave a Reply

Your email address will not be published. Required fields are marked *