Workshop

FORD 5R55S/5R55W

Figure 141
REAR PLANETARY
RING GEAR
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
81
Copyright © 2004 ATSG
8. Rotate transmission in fixture so that front of
case is facing up, as shown in Figure 140.
9. Install the reverse band into transmission, as
shown in Figure 140, ensuring that it engages
on the band anchor lugs in the case.
10. Compress the reverse band enough to engage
the reverse band laver into the notches in the
reverse band.
11. Install reverse drum and low sprag assembly
into the reverse band, as shown in Figure 140,
by rotating in a clock-wise direction untill it
falls into position.
12. Install rear planetary ring gear thrust bearing
(No. 10) into the case in the direction that is
shown in Figure 140.
13. Install the pre-assembled rear planetary ring
gear that has the seal ring with the notches in
it, as shown in Figure 141, and ensure that it is
fully seated against bearing.
INTERNAL COMPONENTS (Cont'd)
Copyright © 2004 ATSG
Figure 140
REVERSE DRUM
AND LOW SPRAG
ASSEMBLY
LOW/REVERSE
BAND ASSEMBLY
REAR PLANETARY
RING GEAR THRUST
BEARING (NO. 10)
Continued on Page 82

Leave a Reply

Your email address will not be published. Required fields are marked *