Workshop

FORD 5R55S/5R55W

6. Install the number 11 thrust washer into rear
of case, as shown in Figure 131, and retain
with a small amount of Trans-Jel®.
Figure 129 Figure 131
Figure 130
Copyright © 2004 ATSG
Copyright © 2004 ATSG
NUMBER ELEVEN
THRUST WASHER
Continued on Page 78
TRANSMISSION CASE ASSEMBLY
1. Inspect the transmission case thoroughly for
wear, damaged surfaces, or stripped threads.
2. Inspect the rear case caged needle bearing and
replace as necessary using the appropriate tools
to remove and install (See Figure 131).
Note: If replacement is necessary ensure that
the sealing ring end of the bearing faces rear,
as shown in Figure 131.
3. Install new manual lever seal into case using
the appropriate seal driver (See Figure 129).
4. There are two different styles of manual lever
design, as shown in Figure 129.
5. Install the manual lever, inside detent lever and
park rod assembly, manual lever retaining pin
and torque nut to 48Nm (35 ft.lb.). Refer to
Figure 130.
Note: Do Not allow the wrench to strike the
manual valve inner detent lever pin.
MANUAL LEVER
RETAINING PIN
INSIDE DETENT
LEVER
PARK ROD
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
76
MANUAL
LINKAGE
SEAL
MANUAL
LINKAGE
MANUAL LINKAGE
RETAINING PIN
Copyright © 2004 ATSG
If Bearing Replacement
Is Necessary, Ensure
Sealing Ring Faces Rear

Leave a Reply

Your email address will not be published. Required fields are marked *