Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
74
Copyright © 2004 ATSG
EXTENSION/4WD ADAPTER HOUSING
1. Inspect the 2WD extension housing bushing
for any wear and/or damage.
2. Replace the 2WD extension housing bushing
as necessary, using the appropriate puller and
bushing driver. Use Figure 123 as a guide.
3. Install a new extension housing yoke seal, as
shown in Figure 123, using the appropriate
seal driver.
4. If you have a 4WD, install new adapter housing
seal, as shown in Figure 124, using the proper
seal driver.
5. Turn the 2WD extension housing or the 4WD
adapter housing over to install the park pawl
components, as shown in Figure 125, as the
procedure is the same for either model.
6. Install the parking pawl return spring onto the
adapter housing, with the leg of the return
spring in front of housing shoulder, as shown
in Figure 126.
7. Install the parking pawl pivot pin through the
center of return spring, as shown in Figure 127.
8. Install the parking pawl over the pivot pin and
hook the return spring on the parking pawl, as
shown in Figure 128.
9. Set the completed extension housing aside for
the final assembly process.
A1L2P-7 039-B
A
Ford
Figure 123
Figure 124
4WD ADAPTER
HOUSING
4WD ADAPTER
HOUSING SEAL
1 P A0 -L
2 -7 38 A
B
®
ordF
Copyright © 2004 ATSG
EXTENSION
HOUSING SEAL
EXTENSION
HOUSING
2WD MODELS
EXTENSION
HOUSING
BUSHING

Leave a Reply

Your email address will not be published. Required fields are marked *