Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
73
SOLENOID BODY ASSEMBLY
SOLENOID BODY ASSEMBLY
COMPLETED SOLENOID BODY ASSEMBLY5R55W/S SOLENOID BODY GASKET
1. The solenoid body is serviced as a complete
assembly only, from Ford Motor Company,
however the aftermarket gasket sets do come
with a new gasket and "O" rings.
2. Remove the worm track plate by prying back
the locking tabs (See Figure 121).
3. Remove and discard the solenoid body to
worm track plate gasket (See Figure 121).
4. Remove and discard the two solenoid body to
case "O" rings, as shown in Figure 121.
5. Ensure that you have the proper gasket for the
5R55W/S, as shown in Figure 120. Refer to
Figure 119 for the differences.
6. Install the new solenoid body to worm track
plate gasket over the dowels on the solenoid
body, as shown in Figure 121.
7. Install the worm track plate over the dowels
on the solenoid body, as shown in Figure 121,
and snap into position.
8. Install two new solenoid body to case "O" ring
seals, as shown in Figure 121.
9. Set the completed solenoid body aside for the
final assembly process (See Figure 122).
Copyright © 2004 ATSG
Copyright © 2004 ATSG
Copyright © 2004 ATSG
12394
12394
Figure 120 Figure 122
Figure 121
4
3
2
1
1. SOLENOID BODY WORM TRACK PLATE
2. SOLENOID BODY TO WORM TRACK PLATE GASKET
3. SOLENOID BODY TO CASE "O" RINGS (2 REQUIRED)
4. SOLENOID BODY ASSEMBLY

Leave a Reply

Your email address will not be published. Required fields are marked *