Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
61
Figure 105 Figure 106
SUN GEAR SHELL ASSEMBLY
Copyright © 2004 ATSG Copyright © 2004 ATSG
SUN GEAR AND
SHELL ASSEMBLY
SUN GEAR AND SHELL ASSEMBLY
1. The sun gear and shell cannot be disassembled.
Refer to Figure 105.
2. Inspect the sun gear and shell parts thoroughly
for any wear and/or damage.
3. Clean all sun gear shell parts thoroughly and
dry with compressed air.
COMPLETED
RING GEAR
ASSEMBLY
NUMBER 6B
THRUST WASHER
FRONT INTERNAL
RING GEAR
FRONT INTERNAL
RING GEAR HUB
FRONT INTERNAL
RING GEAR HUB
SNAP RING
FRONT RING GEAR AND HUB ASSEMBLY
1. Inspect all rear ring gear parts thoroughly as
shown in Figure 106.
2. Assemble the rear ring gear hub into the rear
ring gear and install the snap ring, as shown in
Figure 106.
3. Install the number 6B thrust washer into the
ring gear hub, as shown in Figure 106, retain
with small amount of Trans-Jel®.
4. Set completed rear ring gear and hub assembly,
as shown in Figure 106, aside for the final
assembly process.
5. Refer to Figure 107 and 108 for exploded view
of complete gear train parts.
Component Rebuild
Continued on Page 64

Leave a Reply

Your email address will not be published. Required fields are marked *