Workshop

FORD 5R55S/5R55W

AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
51
Figure 81
Copyright © 2004 ATSG
DIRECT CLUTCH
HOUSING ASSEMBLY
8
DIRECT CLUTCH
PISTON RETURN
SPRINGS (20)
DIRECT CLUTCH
RETURN SPRING
RETAINER
DIRECT CLUTCH
RETURN SPRING
RETAINER SNAP RING
Figure 82
8
Copyright © 2004 ATSG
DIRECT CLUTCH
BACKING PLATE
SNAP RING
DIRECT CLUTCH
BACKING PLATE
DIRECT CLUTCH
INSIDE SPLINE
PLATES (5 Req)
DIRECT CLUTCH
OUTSIDE SPLINE
PLATES (5 Req)
DIRECT CLUTCH
HOUSING
"Selective" Snap Ring
15. Install the direct clutch backing plate, as shown
in Figure 82.
16. Install the direct clutch backing plate snap ring,
as shown in Figure 82 and ensure that it is fully
seated in the groove (See Figure 82).
17. Install dial indicator on top of backing plate, as
shown in Figure 83, and check the direct clutch
clearance. Should be 1.3-2.0mm (.051"-.079"),
as shown in Figure 83.
18. Change the selective backing plate snap ring as
necessary, using the chart in Figure 83, to get
the proper direct clutch clearance.
19. Set the completed direct clutch housing aside
for the final assembly process.
DIRECT CLUTCH ASSEMBLY (Cont'd)

Leave a Reply

Your email address will not be published. Required fields are marked *