Workshop

FORD 5R55S/5R55W

7. DIRECT CLUTCH RETURN SPRINGS (20 REQUIRED).
8. DIRECT CLUTCH PISTON.
9. DIRECT CLUTCH INNER LIP SEAL.
10. DIRECT CLUTCH OUTER LIP SEAL.
11. DIRECT CLUTCH HOUSING.
1. DIRECT CLUTCH BACKING PLATE "SELECTIVE" SNAP RING.
2. DIRECT CLUTCH BACKING PLATE.
3. DIRECT CLUTCH "SINGLE SIDED" INSIDE SPLINE PLATES.
4. DIRECT CLUTCH "SINGLE SIDED" OUTSIDE SPLINE PLATES.
5. DIRECT CLUTCH SPRING RETAINER SNAP RING.
6. DIRECT CLUTCH RETURN SPRING RETAINER.
8
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
49
DIRECT CLUTCH ASSEMBLY
1. Disassemble the direct clutch assembly using
the illustrations in Figure 77 as a guide.
2. Remove and discard the direct clutch lip seals,
as shown in Figure 77.
3. Inspect all direct clutch parts thoroughly for any
wear and/or damage.
4. Clean all direct clutch parts thoroughly and dry
with compressed air.
Figure 77
1
2
3
4
5
6
7
8
9
10
11
Copyright © 2004 ATSG
DIRECT CLUTCH EXPLODED VIEW
Continued on Page 50

Leave a Reply

Your email address will not be published. Required fields are marked *